Our Whirlpool refrigerator had an annoying plastic film left over. I tried several methods before figuring out how to do it with a sharp blade and the right Using a Heat Gun to Remove the Film. From a distance of about 8 to 12 inches from the surface of the vehicle, we hold the heat gun over an area of the protective film. The heat gun will, after a moment or two, begin to soften the film, making it easier to manipulate and peel. We are careful to make sure that the heat gun gets no closer to the In this video I will be showing you how to remove clear bra (paint protection film) the right way. I will be using a steamer to remove the film. The vehicle If stubborn debris still remains, try using a blue clay bar. (Never reuse a red clay bar or a piece of old clay, which could damage the surface of the bra.) If you use Dawn or clay bar, reapply a coat of protectant over the affected areas. A quick wax or Plexus wax with polish will often remove stubborn spots on the bra’s surface. Step 2: Clean with soap and water. Before you start removing the PPF, clean the PPF and the surrounding area with soap and water. This can help remove dust, debris, or dirt that may disrupt the removal process. Wet a rag with a mixture of mild soap+water, then wipe down the area around the PPF. Step 3: Peel off the film from the window. After removing the tint, peeling off the film will take less time. The sheet becomes weak and comes off nicely. To remove the film, use a razor blade and strip the sheets from the corners. Apply heat using a blow dryer with one hand and with the other handset an angle to peel the film with a sharp 1. Microfiber cloth: A soft, lint-free cloth is essential for cleaning the screen protector and removing any residue or fingerprints. 2. Credit card or plastic scraper: You’ll need a sturdy but flexible tool to gently lift the edges of the screen protector and separate it from the phone’s screen. 3. Use a plastic razor blade or scraper to gently lift and peel the vinyl away from the surface of the car. Work slowly and carefully, applying heat as needed to keep the vinyl pliable. Avoid pulling the vinyl at a sharp angle, as this can damage the paint. Keeping the vinyl at a 25° to 40° angle is the safest when removing the vinyl. 36xrLD.